Author Topic: updation of firmware of overhead controller  (Read 4268 times)

monika137

  • Jr. Member
  • **
  • Posts: 4
  • Karma: +0/-0
updation of firmware of overhead controller
« on: March 25, 2015, 08:41:08 AM »
when i tried to update the firmware of OHC according to the link given below

https://www.kilobotics.com/documentation

when i executed the command:- avrdude -p m328  -P usb -c avrispmkII -U "flash:w:controller.hex:i"

it displays error that m328 not found.

prahladdas

  • Jr. Member
  • **
  • Posts: 7
  • Karma: +0/-0
Re: updation of firmware of overhead controller
« Reply #1 on: April 08, 2015, 08:18:47 PM »
Same problem with me also. K-team reply soon.......

kteam

  • Administrator
  • Hero Member
  • *****
  • Posts: 378
  • Karma: +7/-1
Re: updation of firmware of overhead controller
« Reply #2 on: April 13, 2015, 09:03:57 AM »
Hi,

you can update the OHC firmware using the KilobotInterface.hex or AVR studio.

Best regards

handson

  • Jr. Member
  • **
  • Posts: 3
  • Karma: +0/-0
Re: updation of firmware of overhead controller
« Reply #3 on: August 19, 2015, 10:19:29 AM »
Hi Kteam,
Could you explain more in detail how to update the OHC firmware? Thanks

kteam

  • Administrator
  • Hero Member
  • *****
  • Posts: 378
  • Karma: +7/-1
Re: updation of firmware of overhead controller
« Reply #4 on: August 25, 2015, 09:35:07 AM »
Hi,

The best way to update the OHC firmware is to use AVRstudio the same way you flash an Atmega microcontroller.
Open AVRstudio, goes in Tools->Program AVR->Connect. Select the AVRispMkII as a programmer.

Then you must select the Atmega328 as microcontroller. In the Program Tab, load your new firmware and press program.

Best regards
K-team

m-parhizkar

  • Jr. Member
  • **
  • Posts: 5
  • Karma: +0/-0
Re: updation of firmware of overhead controller
« Reply #5 on: December 18, 2018, 11:11:15 AM »
Hi,

Check this out:

https://www.k-team.com/forum/index.php/topic,1914.0.html

Cheers!