Author Topic: Code for the controller  (Read 3145 times)

rudasi

  • Jr. Member
  • **
  • Posts: 6
  • Karma: +0/-0
Code for the controller
« on: November 05, 2015, 05:18:15 PM »
Hello,

I was hoping to find code for the OHC. All I could find is the controller.hex file, is code available?

Thanks,
Rahul

kteam

  • Administrator
  • Hero Member
  • *****
  • Posts: 378
  • Karma: +7/-1
Re: Code for the controller
« Reply #1 on: November 09, 2015, 04:28:15 PM »
Hi,

the source code is not directly available. Please ask k-team by e-mail to obtain it.

Best regards

rudasi

  • Jr. Member
  • **
  • Posts: 6
  • Karma: +0/-0
Re: Code for the controller
« Reply #2 on: November 10, 2015, 10:14:49 PM »
Thanks, I obtained the source code. I compiled the code and flashed into onto the OHC but could not get the controller to work (I tried the toggle led command). When I created the project I set the device to atmega328. I ran md5sum on the the original Controller.hex file and the one I generated based on the source code I was sent and they were different (the original could be made with slightly different source code). Any suggestions on what I might be doing wrong?

Thanks,
Rahul

kteam

  • Administrator
  • Hero Member
  • *****
  • Posts: 378
  • Karma: +7/-1
Re: Code for the controller
« Reply #3 on: November 13, 2015, 08:40:04 AM »
Hi,

sorry, but this source was the original given by Harvard. We have never modify it, so the only solution is to contact Harvard directly.
You can ask to Mike Rubenstein directly, you will find his e-mail here http://people.seas.harvard.edu/~mrubenst/

Best regards