K-Team Support Forum

General Category => Kilobot => Topic started by: monika137 on March 25, 2015, 08:41:08 AM

Title: updation of firmware of overhead controller
Post by: monika137 on March 25, 2015, 08:41:08 AM
when i tried to update the firmware of OHC according to the link given below

https://www.kilobotics.com/documentation

when i executed the command:- avrdude -p m328  -P usb -c avrispmkII -U "flash:w:controller.hex:i"

it displays error that m328 not found.
Title: Re: updation of firmware of overhead controller
Post by: prahladdas on April 08, 2015, 08:18:47 PM
Same problem with me also. K-team reply soon.......
Title: Re: updation of firmware of overhead controller
Post by: kteam on April 13, 2015, 09:03:57 AM
Hi,

you can update the OHC firmware using the KilobotInterface.hex or AVR studio.

Best regards
Title: Re: updation of firmware of overhead controller
Post by: handson on August 19, 2015, 10:19:29 AM
Hi Kteam,
Could you explain more in detail how to update the OHC firmware? Thanks
Title: Re: updation of firmware of overhead controller
Post by: kteam on August 25, 2015, 09:35:07 AM
Hi,

The best way to update the OHC firmware is to use AVRstudio the same way you flash an Atmega microcontroller.
Open AVRstudio, goes in Tools->Program AVR->Connect. Select the AVRispMkII as a programmer.

Then you must select the Atmega328 as microcontroller. In the Program Tab, load your new firmware and press program.

Best regards
K-team
Title: Re: updation of firmware of overhead controller
Post by: m-parhizkar on December 18, 2018, 11:11:15 AM
Hi,

Check this out:

https://www.k-team.com/forum/index.php/topic,1914.0.html

Cheers!